Page 2 of 2

Re: Night switch for steam engines based on combinators

Posted: Sun Aug 02, 2015 6:27 am
by Zhab
MadZuri wrote:If I had access to the wiki, I would prolly delete ...
Well they don't need to give you access to include your design in the wiki. They just need your permission to do so.
MadZuri wrote:Edit: Maybe not delete, but add some heavy caveats as to when they are applicable, including pros and cons to each type of design. Belt swappers are completely useless, rebalancers are a sign of poor design (its better to design an inherently balanced system or only feed one side and have a simple 1-splitter balancer) and buffer systems should be limited to what you can easily move in under a minute or for the 2 important exceptions: fuel for power systems or oil barrels. Don't get me started on the whole rail loops vs intersections thing...
Well good wiki should expose pros and cons of both sides when covering controversial subjects. That is actually a rule on wikipedia. Especially about science subjects with clashing theories.

Re: Night switch for steam engines based on combinators

Posted: Wed Aug 05, 2015 11:08 pm
by vampiricdust
When I get home I will post some images on a night detector that needs a pole, tank, water pump, small pump, and a combinator. It can make a pretty fune controlled power switch with a few combinators and small pumps.

Re: Night switch for steam engines based on combinators

Posted: Fri Aug 21, 2015 4:31 pm
by Legoman165
Reticality wrote: Remember you can shift right click power poles to disconnect them and use the copper cable item to connect specific poles.
I didn't know that was a thing!