Re: 0.12.26 alpha - Inserters get stuck feeding stone to furnace
Posted: Sun Mar 27, 2016 3:17 am
Okay, I'll bite on this one. Here's another way that we can get the same behaviour (stuck inserter):
* Have a belt with different items on each side.
* Set up an assembler that takes only one of the items
* Blueprint it
* Lay the blueprint down
Now, the following may occur, and result in a stuck inserter:
* The robots place the inserter and belt before the assembler
* The belt fills up before the assembler is placed
* The inserter picks up the "wrong" item before the assembler goes down
If the above occurs, you get the same situation.
* Have a belt with different items on each side.
* Set up an assembler that takes only one of the items
* Blueprint it
* Lay the blueprint down
Now, the following may occur, and result in a stuck inserter:
* The robots place the inserter and belt before the assembler
* The belt fills up before the assembler is placed
* The inserter picks up the "wrong" item before the assembler goes down
If the above occurs, you get the same situation.