Factorio Forums

insert is stuck. assembler has exoskeletons in it but lower left stack inserter won't move item. if removed & replaced, it works correctly.

Hello, I checked your save, and it doesn't look like a bug to me.
When you open the assembling machine, you can see that the output is full (it even states that in the status).
When the assembling machine has a full output, it doesn't accept new items, this is intended behaviour.

kovarex wrote: ↑

Tue Jan 26, 2021 3:23 pm

Hello, I checked your save, and it doesn't look like a bug to me.
When you open the assembling machine, you can see that the output is full (it even states that in the status).
When the assembling machine has a full output, it doesn't accept new items, this is intended behaviour.

He meant output inserter: " lower left stack inserter"

The reason it's waiting it's because of logistic condition that was forgotten to portable fusion reactors. Remove or update the logistic condition and it will work.

I fixed it by removing the inserter, & remaking the condition. At that point it worked as intended.

If you do a "blueprint cut" & paste it back down in the exact same place, it starts working correctly.

The condition is "exoskeleton under 2" to activate the inserter and the chest has nothing in it. Twinsen, are you saying I have an extra wire somewhere that's messing it up?

I think that's the wrong one. I'm not near the computer to check. It should be the inserter on the left side, bottom slot, next to the exoskeleton assembler. The insert puts it into a yellow chest. I did a cut/paste of the two inserters and storage chest, and it worked as intended.