Shift + Mouse up/down only cycles blueprint names, not the actual blueprints
Posted: Sat Dec 09, 2023 4:58 pm
When I hold shift and scroll the mouse wheel while holding a blueprint book, only the names of blueprints in a book are cycled, the shown blueprint stays the same at all time.
I am not 100% sure when this first happened, but I think it was after updating from 1.1.8x to 1.1.92. Now I updated to 1.1.94, and this is still broken
I am not 100% sure when this first happened, but I think it was after updating from 1.1.8x to 1.1.92. Now I updated to 1.1.94, and this is still broken