Factorio Forums

While locomotive a bit turned like on video below, insetret wont grab fuel. But if i re-build inserter- it works. Video below. Think its happend while previously locomotive moved from another rail position - inserter did last swing but locomotive is full, and next locomotive cant use inserter's saved swing from another position (but it can cover both position cuz remove-rebuild inserter works well)

Thanks for the report however I don't believe there is a solution to this on the engine side that won't have performance implications even outside of this case. The inserter is sleeping in the straight rail and the train is on the curved rail. If you want to make sure it works, simply don't have the train stop directly at he end of a curve and straight rail combination where the inserters may not interact with the section the train arrives on.

Kk, ty4answer