Belts not fully unloading onto other belt after a curve
Posted: Fri Feb 02, 2018 10:02 pm
Hi,
I dont know if this is a known issue and its not thaaaat bad, I can work around it, but its kind of bugging(hehe) me.
Like seen in the video, the copper plates come from the bottom, turn right and should unload onto the belts coming from the top. Only the upper side of the belt gets taken over though, so the left side of the belt going down doesnt get fully loaded(which it should). If I place a belt above the one going down(which should have no effect at all on whats going on in that intersection) it starts working for a short while and then goes back to not working again. Placing another belt above has the same effect, every new belt placed above doesnt do anything anymore though.
I am not using any mods and am running the latest experimental version.
Video of the issue:
https://streamable.com/flmcy
I couldnt upload it using the Attachment tab because its an mp4 and didnt find what format I need to convert it to...
Sorry for the bad quality, I didnt take the time to install a screen capturing software. If neede I can do it though to get some better quality video of the issue.
Hope you guys can work with what I provided.
edit: Im absolutely sure that its not just because there are less plates coming into the splitter just at the time I place the belt, I did the exact same thing about 10 times before filming it with all the same results.
Best regards,
Thomas
I dont know if this is a known issue and its not thaaaat bad, I can work around it, but its kind of bugging(hehe) me.
Like seen in the video, the copper plates come from the bottom, turn right and should unload onto the belts coming from the top. Only the upper side of the belt gets taken over though, so the left side of the belt going down doesnt get fully loaded(which it should). If I place a belt above the one going down(which should have no effect at all on whats going on in that intersection) it starts working for a short while and then goes back to not working again. Placing another belt above has the same effect, every new belt placed above doesnt do anything anymore though.
I am not using any mods and am running the latest experimental version.
Video of the issue:
https://streamable.com/flmcy
I couldnt upload it using the Attachment tab because its an mp4 and didnt find what format I need to convert it to...
Sorry for the bad quality, I didnt take the time to install a screen capturing software. If neede I can do it though to get some better quality video of the issue.
Hope you guys can work with what I provided.
edit: Im absolutely sure that its not just because there are less plates coming into the splitter just at the time I place the belt, I did the exact same thing about 10 times before filming it with all the same results.
Best regards,
Thomas