[0.17.52] crash on save - incomingBlock->getOutboundSignals().count(...) was not true

cbabendure · Post by **cbabendure** » Fri Jun 28, 2019 5:47 am

I am not using any mods. All you have to do is load up the save and wait for the next autosave, for me it crashes regardless of what I am doing.

Post by **Rseding91** » Fri Jun 28, 2019 9:10 am

Please posts the log file.

Post by **Dominik** » Fri Jun 28, 2019 9:23 am

Yeah, log file, log file!
I tried the save in 17.52 and autosave went through fine.

cbabendure · Post by **cbabendure** » Sat Jun 29, 2019 12:39 am

Sorry thought I had, is this the right one?

The timestamp will be different as I tried it again today and had the same crash, but it it otherwise seems like the same issue.

cbabendure · Post by **cbabendure** » Sat Jun 29, 2019 4:33 am

Hey guys, I did some more testing and figured out a more reliable way to trigger the save failure.

Attached is a new save file. If you put a train signal in the indicated spot in the attached image and try to save the game, the save will fail and the game will crash.

: Cause.JPG (232.35 KiB) Viewed 1878 times

Good luck with the bug busting!

cbabendure · Post by **cbabendure** » Sat Jun 29, 2019 4:38 am

And it looks like this behavior has already been identified here:
viewtopic.php?f=182&t=72534#p438798

Although, in the attached save a manual save is able to crash the game just as well as an autosave. Maybe there is a little more going on?

Anyway, sorry about the duplicate, but I guess at least this is already on your radar.

Factorio Forums

[0.17.52] crash on save - incomingBlock->getOutboundSignals().count(...) was not true

[0.17.52] crash on save - incomingBlock->getOutboundSignals().count(...) was not true

Re: Crash while saving

Re: Crash while saving

Re: Crash while saving

Re: Crash while saving

Re: Crash while saving