[2.0.59] Assemblers 1 animation is not perfectly looped
Posted: Thu Jul 10, 2025 1:39 pm
1. What did you do?
I looked at the Assembler 1 animation.
2. What happened?
The Assembler 1 animation is not perfectly looped, some of the gears jump back/forward a bit when the animation restarts. Refer to the attached video, it can be seen when the metal I-beam in the top left reaches it's left side, the gears on the right jump a bit. 3. What did you expect to happen instead? It might be obvious to you, but do it anyway!
The animation for Assembler 1 should be perfectly looped.
4. Does it happen always, once, or sometimes?
Happens all the time.
Log file:
I looked at the Assembler 1 animation.
2. What happened?
The Assembler 1 animation is not perfectly looped, some of the gears jump back/forward a bit when the animation restarts. Refer to the attached video, it can be seen when the metal I-beam in the top left reaches it's left side, the gears on the right jump a bit. 3. What did you expect to happen instead? It might be obvious to you, but do it anyway!
The animation for Assembler 1 should be perfectly looped.
4. Does it happen always, once, or sometimes?
Happens all the time.
Log file: