[2.0.59] Assemblers 1 animation is not perfectly looped

[FrozenTaco]

1. What did you do?
I looked at the Assembler 1 animation.

2. What happened?
The Assembler 1 animation is not perfectly looped, some of the gears jump back/forward a bit when the animation restarts. Refer to the attached video, it can be seen when the metal I-beam in the top left reaches it's left side, the gears on the right jump a bit.

2025-07-10 15-32-13.mp4

(6.65 MiB) Downloaded 25 times

3. What did you expect to happen instead? It might be obvious to you, but do it anyway!
The animation for Assembler 1 should be perfectly looped.

4. Does it happen always, once, or sometimes?
Happens all the time.

Log file:

factorio-current.log

(11.75 KiB) Downloaded 6 times

[Rseding91]

Thanks for the report however I don't think this will be changing unless some new assembler graphics are created.