UPS Optimization - Green Science Ore In (editor)

[Belter]

Target: 100x1 full blue belt of Green Sci pack, best UPS wins - "Ore In"

I have to admit working on these blueprints is more interesting and "factorio-like" than onshore setups. Also people might be able to re-use the ideas here better. Rules are same as in the UPS Optimization - Green Science (editor) thread.
BUT: Ore must come in the left on belt(s) and Green Science must leave on the right on a fully saturated blue belt.

Results - 2023-09-17

1. UPS: 173 - Belter OreIn v1.0 (5B/6B, not timed): Forum / FactorioBox
2. UPS: 152 - Belter OreIn v2.0 (8B, not timed): Forum / FactorioBox
3. UPS: 138 - Belter OreIn v3.0 (10B, not timed): Forum / FactorioBox
4. UPS: 95 - Belter OreIn v0.1 (12B, not timed): Forum / FactorioBox

Map setup

- Please create 2 vertical lines from Concrete Hazard as below

On the left: produce Ore however you like

- Allowed: 1 Elecrtic energy interface (to produce infinite power
- Allowed: Infinity chest(s): to produce Ore easily
- Allowed: Express loader(s): to get Ore out of the infinity chest to the belt
- Optionally you can use mines also - as mining prod is at 2000% an Electric Mining Drill w/SM3s can produce a full half belt
- You can put ore patches in editor mode if you want
- Ore belt(s) and power line(s) to cross the Hazard line only

OreIn.png (46.35 KiB) Viewed 1139 times

In the middle: produce the Green Science Packs - no mining

- Vanilla only: no editor entities and no mining here
- Put signalling here also

On the Right: Green Science to Come out

- 1 fully saturated blue Ore belt to come out. Gap: you're out
- Allowed: 1 Express loader + 1 Infinity chest to consume the packs
- Green Science belt and power line(s) to cross the Hazard line ony

PacksOut.png (14.71 KiB) Viewed 1139 times

See the 2nd post for an example savegame or the TL;DR pic here:

GreenScienceUPS Editor OreIn-.png (1.09 MiB) Viewed 1152 times

[Belter]

Belter OreIn v0.1 - for baseline

- This is the map shown in the first post.
- I digged this out from a very-very, very old savegame..
- Here just for a baseline, really bad for UPS. Zero DI, tons of unecessary inserters, splitters etc.
- But it is 12B
- 95 FPS for me: https://factoriobox.1au.us/map/info/d82 ... 12dfee1919

[Belter]

Belter OreIn v1.0

- My fully DI solution created from this version which is in the other thread.
- 5B/6B Beacon setup
- 4.1% over production in GS
- No timing
- 173 UPS for me: factoriobox
- That's a surprise that this is the fastest from v1/2/3

Green Science UPS OreIn Editor - Belter v1.0.png (709.42 KiB) Viewed 1137 times

[Belter]

Belter OreIn v2.0

- Almost full DI
- 8 Beacon setup
- 2.7% over prodcution
- No timing yet
- 152 UPS for me: https://factoriobox.1au.us/result/3a273 ... e617edd91d

Green Science UPS OreIn Editor - Belter v2.0.png (240.2 KiB) Viewed 1134 times

[Belter]

Belter OreIn v3.0

- Almost full DI
- 10 Beacon setup
- I've spent the most time on this setup so far, I like the honeycomb power line pattern
- One iron belt was not enough, so in the middle it changes to the 2nd
- No timing yet
- 138 UPS for me: https://factoriobox.1au.us/map/info/dd3 ... 2887ba275b
- I thought this will be the best from v1/2/3, far from it

Green Science UPS OreIn Editor - Belter v3.0.png (242.68 KiB) Viewed 1131 times