[0.17.76] Train Rectangle Misalignment

[wizard07ksu]

When placing an inserter next to a rail segment in a station when a train is in the station, the selector that appears showing the train car affected by the inserter is misaligned with the segment. See figure 1:

Shows misaligned selector.

Horizontal misaligned.png (1.13 MiB) Viewed 896 times

This only happens when the inserter is actually adjacent to the rail segment, however:

Shows selector without adjacent inserter

Horizontal basic.png (3.59 MiB) Viewed 896 times

To highlight the incorrect placement, I marked up this image:

Highlights misaligned selector

Horizontal misaligned (markup).png (1.08 MiB) Viewed 896 times

This even occurs when the target train object isn't a locomotive, or the first object in a train, or the inserter is pointing away from the train:

Misaligned on 3rd object in train, a wagon

Horizontal wagon.png (1.83 MiB) Viewed 896 times

Since I was trying to place a blueprint when I noticed this, I tried without a blueprint. Same problem:

Misaligned with no blueprint

Horizontal no blueprint.png (627.44 KiB) Viewed 896 times

Vertical trains are still slightly off, though. Here's the basic selector for a vertical train:

Vertical selector without adjacent inserter

Vertical basic.png (2.67 MiB) Viewed 896 times

And a vertical train when I'm placing an inserter adjacent to it:

Vertical selector with adjacent inserter

Vertical misaligned.png (1.84 MiB) Viewed 896 times

But this issue ONLY happens when a train is in the station:

Horizontal no train.png (1.69 MiB) Viewed 896 times

Vertical no train.png (1.78 MiB) Viewed 896 times

To show where I would expect the highlighting selector to appear, I marked up this image:

Shows where selector is expected to appear

Vertical basic (markup).png (2.1 MiB) Viewed 896 times

Looking through the debug options all the collision boxes appeared to be correct, so this looks like it might just be a visual thing.

[boskid]

Not a bug

First is to show alignment with train station and is on rails and second is based on selection box for locomotive that renders to show that inserter will connect to given entity.