[2.0.55] Fusion Reactor not sending Plasma to some of its Generators

Post your bugs and problems so we can fix them.
Post Reply
Copy link
SpiritKid
Burner Inserter
Burner Inserter
Posts: 6
Joined: Wed Dec 11, 2024 5:22 am
Contact:
Contact SpiritKid

[2.0.55] Fusion Reactor not sending Plasma to some of its Generators

Post by SpiritKid »

What did you do?
Placed this blueprint for a 3.5GW Fusion Reactor

Blueprint:


What happened?
Only about 3GW is available and part of the reactor is not receiving Plasma
What did you expect to happen instead? It might be obvious to you, but do it anyway!
3.5GW to be available and for all of the generators to be receiving Plasma
Does it happen always, once, or sometimes?
Always

The bottom left area of the screenshot shows 4 generators not receiving Plasma. If I remove the lower of the 3 active generators in the bottom left section, the other generators all immediately receive Plasma and start working again.

I noticed 128029/122346, but I haven't been able to get them to change by deconstruction or by removing power load from them or anything yet, and that bug was marked fixed in an older version than this. Could be the same issue, the generator with an output pointing into the reactor in/out causing it.
06-12-2025, 10-26-55.png
06-12-2025, 10-26-55.png (1.64 MiB) Viewed 363 times
Attachments
factorio-current.log
(14.91 KiB) Downloaded 31 times
Top
Post Reply

Return to “Bug Reports”