What did I do: placed a parameterized blueprint, then before setting or accepting any parameters, double clicked off to the side of the Parameter UI (in my case just one tile to the right of where the blueprint was set to place initially). This opened up a different parameter UI, which I set without issue, bringing the original Paramater UI back into focus. When testing in the "Testing" Scenario, this occurred on clicking the signal rather than on clicking to confirm the signal.
- After setting first blueprint part
- 01-19-2025, 12-11-45.png (90.04 KiB) Viewed 343 times
- just before crash, clicking the green checkmark in 'select a signal' causes it.
- 01-19-2025, 12-13-35.png (808.21 KiB) Viewed 343 times
- Crash Message
- 01-19-2025, 12-14-32.png (19.73 KiB) Viewed 343 times
What would I expect to happen: either disable stacking of parameterized blueprints, or for this behavior to not cause a crash.
Does this always happen? When following the reproduction steps, this will always happen, Specifically on setting the signal, values do not cause any issues
BP used to reproduce:
0eNqFUdtKxDAQ/ZVlntNlWzcLDfjiFwiKLyJL2kYN5FKTdLGU/Lsz3W1FRSUvkzkzc86cmaAxg+qDdgnEBLr1LoJ4nCDqFycN5Zy0CgQQkqRLRetto51MPkBmoF2n3kGU+YmBckknrc4D5s94dINtVMAC9tcgBr2P2OsdMeK8oirLLWcwgjjsthyJsC0Fb46NepUnjT1YGFVLPfFrjOSLKgbP2iQVvmcvUnoZMEC82KGEt0EalIx554PF5YnUUg1JFHA9JwZyCtfFl2npdcaZI409TdYdrCx3s5Wbe0IYIb8QoyGuW034X03ObOW72MyWQED5Q8CDxFMDadZJWcx/np6BkY3Cc8ONjLrd3C76EDnharMmfqjqfV1zvudVfVXm/AHrrL+t
